Full-Service Auto Detailing & Paint Correction in Chilliwack, BC · Serving the Fraser Valley
Interior deep-cleans, machine polish, paint correction, and ceramic coating from one Chilliwack shop. Drop it off, drive home in a car that feels new again.
A real detail is measured in hours, not minutes. We strip what the Fraser Valley leaves behind — Highway 1 road film, pollen, winter salt — then correct, protect, and dress every surface. Inside or out, the standard is the same: finished means finished.
Every seat, seam, and vent.
Hot-water extraction on carpets and seats, steam on vents and trim, and safe conditioning for leather. Coffee spills, dog hair, and mystery odours leave for good.
Details →02Depth a drive-through can’t touch.
Hand wash, clay decontamination, and a single-stage machine polish that lifts light swirls and restores gloss. The paint feels slick because it finally is.
Details →03Swirls out. Clarity back.
Multi-stage machine correction removes swirl marks, water etching, and light scratches, then refines the finish to a true mirror. Measured, not guessed — we gauge the paint first.
Details →04Protection you can see.
A professional-grade ceramic layer bonds to corrected paint and holds its gloss through Valley winters. Rain sheets off, and washes take half the time.
Details →05Clean under the hood too.
Careful degreasing, a low-pressure rinse, and dressing bring the bay back to showroom. Sensitive components are covered before a drop of water goes in.
Details →Interior, exterior, correction, and coating under one roof — no hand-offs, no excuses.
Every vehicle follows a written checklist, and nothing leaves until it passes a final inspection under lights.
We run pro-line chemicals and pads chosen by results on real paint, not by a distributor’s pitch.
We’re on Yale Road in Chilliwack — call and a person answers, not a menu.
Plan on most of a day for a complete interior and exterior detail. Correction and coating work can run two days — we confirm timing when you book.
Yes. Extraction, steam, and enzyme treatment handle almost every odour and embedded hair. Heavy cases may need a follow-up pass, and we’ll say so up front.
We measure paint thickness with a gauge before any machine touches a panel, then remove only what the defect requires. That’s how correction stays safe.
The paint has to be corrected and decontaminated first, or the coating locks in every flaw. We prep and coat as one job so it’s done right.
Mostly Chilliwack and Sardis, but drivers make the trip from Abbotsford, Mission, Agassiz, and Hope. We serve the whole Fraser Valley.
Tell us what you’re after and we’ll get you a straight answer and a time — no pressure, no runaround.